Fiber Patch Panel are blocked by dust particles

  • Unlike copper wire system Fiber Patch Panel do not use and electrical form to carry data. The use of light gives a competitive edge to fiber optics over regular data transmission options. But eventually use of fiber optics is very expensive as compared to copper cabling system.

    Fiber optics are thin filaments of glass through which light beams are transmitted. Advantages of fiber include high information carrying capacity (bandwidth), very low error rates and insensitivity to electromagnetic interference. Then, the bare glass (125 mm) is cleaned and set in place under a special laser below a custom photo mask that is set 50 mm above the cable. Once the laser performs its cycle, the assembly is now customized.

    According to professionals, fiber optic fibers are blocked by dust particles that are as small as 9 micrometers. Due to these high dust sensitivity levels, it's paramount that you ensure that your cables are thoroughly clean before installing them. To help you out, here are the areas that you should clean:

    Receptacles are packaged devices that come with optical ports. They make use of lens based systems that are less sensitive to contamination. You can dry or wet clean them. To dry clean them you need to use lint-free swabs. You should start by switching off the lasers and then remove the protective endcap.

    Different environments also require different types of cabling systems to ensure the fiber stays in good condition. Depending on where you are installing the cable, there are two basic types of fiber cabling systems that can be used.

    One of the best things about the fiber optics is ease of installation. Unlike the other cables which are heavy and complex to establish connection, fiber optic cables are light and flexible to install. The process of installing is similar to any wire cable installation, but the method, tools and instruments require to complete the task is different.

    Following the above guidelines will ensure the proper framing of your site with cable termination box . While lying out the cable there always is a requirement to terminate or elongate the cable. For such cases the technique used in fiber optics is completely different, than for the other conventional cable.